Liebherr G 2433 Betriebsanleitung PDF herunterladen (Seite 3)

Setting the temperature

Press the Up/Down button, the next lower

temperature value in the temperature dis-

play will light up.

Keep pressing the Up/Down button until

the desired value is displayed.

Note

After a certain period of operation, the interior temperature will

adjust to the value which has been set.

Dimensions (mm)

Setting up

• Do not place the appliance in direct sunlight or near cookers,

radiators and similar sources of heat.

• The floor on which the appliance stands should be horizontal and

level. To compensate for any unevenness, adjust the height of the

feet with the open-ended spanner supplied.

• Always ensure good ventilation. Do not cover ventilation openings

or grille.

• Do not place heat-emitting appliances, e.g. microwave oven,

toaster, etc., on top of the freezer.

• Standard EN 378 specifies that the room in which you install your

appliance must have a volume of 1 m

per 8 g of R 600a refrigerant

used in the appliance, so as to avoid the formation of inflammable

gas/air mixtures in the room where the appliance is located in the

event of a leak in the refrigerant circuit. The quantity of refrigerant

used in your appliance is indicated on the type plate on the inside

of the appliance.

• Do not connect the appliance to the supply with other equipment

using an extension cable - risk of overheating.

Connecting to the mains

Power supply (AC) and voltage at the operating point must comply

with the details on the type plate, which is located on the inside

left of the appliance. The socket must be fused with a 10 A fuse

or higher, it must be away from the rear of the appliance and must

be easily accessible.

Connect the appliance with a properly earthed fused plug

and socket only.

G 20 H = 1250 mm

G 24 H = 1447 mm

G 27 H = 1644 mm

Switching the appliance on and o

Switching on: Press the ON/OFF button so that the

temperature display lights up/ashes.

Switching o: Press the ON/OFF button for approx. 3

seconds so that the temperature display goes out.

Operating and control elements

Saving energy

- Always ensure good ventilation. Do not cover ventilation openings

or grille.

- Do not place the appliance in direct sunlight or near cookers,

radiators and similar sources of heat.

- The energy consumption depends on the installation conditions,

e.g. the ambient temperature.

- Keep the time the appliance is open to a minimum.

- Store food logically.

- Keep all food properly packed and covered so as to avoid its

frosting up on the outside.

- Always allow hot food to cool to room temperature before placing

in the appliance.

- If there is a thick layer of frost in the appliance: defrost the appli-

ance.

Accumulated dust increases the energy consumption:

- Once a year, dust the refrigeration unit together with the metal

grid of the heat exchanger at the back of the appliance.

1 Temperature display (display)

2 Temperature button

3 On/O button

4 SuperFrost button

5 Audible warning on/o button

Setup mode is activated (activating the child lock and

adjusting the display brightness)

Alarm (symbol flashes if the temperature inside the appli-

ance is too high)

Child lock is activated

SuperFrost is on

Adjusting the display brightness (this symbol is only acti-

vated in setup mode)

Demo mode is activated

23 4 5

Audible warning signal

It sounds when it is not cold enough in the freezer compartment.

The temperature display and the symbol

ash.

The audible warning device is switched o by pressing the

ALARM button. The temperature display will continue to

ash until the cause of the alarm has been rectied.

This can be caused by:

• the freezer door being left open for a long time, allowing warm

ambient air to enter;

• a long power failure;

• a fault in the appliance.

In each case, make sure food has not thawed or perished.

1 2 3 4 5 6 7

Kommentare zu diesen Handbüchern

Keine Kommentare

Liebherr G 2433 Betriebsanleitung Seite 3

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Nein Liebherr G 2433